Vehicle Height With Steel Springs
WARNING: This page is about a different variant/trim than selected.
Information
- The following values refer to the DIN empty weight (DIN 70020), in other words: full fuel tank, vehicle with tyre sealant or spare wheel (collapsible wheel) and tools, but with no driver and no additional weights.
- Tyre pressure in accordance with specifications.
- If the control unit or one of the level sensors was replaced, carry out a calibration using the Porsche System Tester.
| Vehicle height | Steel springs |
|---|---|
| Front-axle height | |
| With 18, 19, 20, 21-inch wheels [mm] | 479, 2 ±10 |
| From outer wheel centre to lower edge of inner wing | |
| Rear-axle height | |
| With 18, 19, 20, 21-inch wheels [mm] | 472, 6 ±10 |
| From outer wheel centre to lower edge of inner wing | |
| Max. difference in height between left and right: 10 mm |