Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screw | Screw on transmission support | Tightening torque | 70 Nm (52 ftlb.) | ||
| Upper control arm to wheel bearing housing | M12 thread | Tightening torque | 95 Nm (70 ftlb.) | ||
| Tie rod to rear axle housing | M12 thread/always use new screws or bolts and nuts following removal | Tightening torque | 95 Nm (70 ftlb.) | ||
| Fastening screw | Heat shield to frontaxle carrier | Tightening torque | 20 Nm (15 ftlb.) | ||
| Fastening screws | Heat shield to frontaxle carrier | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Fastening screw | Step 1, frontaxle carrier to body | Initial tightening | 115 Nm (85 ftlb.) | ||
| Fastening screw | Step 2, frontaxle carrier to body | Final tightening | + 90° | ||
| Tie-rod ball to tie rod | Counter when loosening and tightening the lock nut on the outer joint | Tightening torque | 90 Nm (67 ftlb.) |