Technical Values

WARNING: This page is about a different variant/trim than selected.

Location	Description	Type	Basic value
Brake calliper (17-inch - black) to wheel bearing housing	Item 2: Screw, M14 x 1.5 x 48/always replace screws/bolts following removal	Tightening torque	196 Nm (145 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Front brake calliper - axial bolts
Brake calliper (17-inch - black/North America) to wheel bearing housing	Item 2: Screw, M14 x 1.5 x 115/always replace bolts following removal	Initial tightening	30 Nm (22 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Front brake calliper - view of radial bolts
Brake calliper (17-inch - black/North America) to wheel bearing housing	Item 2: Screw, M14 x 1.5 x 115/always replace bolts following removal	Final tightening	+ 90°
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Front brake calliper - view of radial bolts (shown as an example)
Brake hose holder to wheel bearing housing and body	Item 2: Screw, M6 x 16	Tightening torque	8 Nm (6 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Brake hose holder to wheel bearing housing
Brake line to brake calliper (grey cast iron)	Item 3: Cap screw - do not bend line	Tightening torque	20 Nm (15 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Brake line on brake calliper