Installing Pressure Pipe
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1
Tighten nuts on pressure pipe.
- Tightening torque 9 Nm (6.5 ftlb.)
- 1.2
Tighten clamp at the bottom.
- Tightening torque 5.5 Nm (4 ftlb.)
- 1.3
Tighten clamp at the top.
- Tightening torque 5.5 Nm (4 ftlb.)