LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (21 Exhaust Gas Turbocharging 2.0L -- 95B - MACAN (95B)) >> WM, 213919 Removing And Installing Moulded Hose (R4) >> Installing Moulded Hose >> Installing Moulded House (Charge Air Cooler - Pressure Pipe)

Installing Moulded House (Charge Air Cooler - Pressure Pipe)

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screw-type clamp on moulded hose at the bottom of the pressure pipe.
      • Tightening torque 5.5 Nm (4 ftlb.) 
    2. 1.2  Tighten screw-type clamp on left charge air cooler.
      • Tightening torque 5.5 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals