Subsequent Work
- Install evaporator/compressor line, but do not
add refrigerant yet.
> 874519 - REMOVING AND INSTALLING EVAPORATOR/COMPRESSOR LINE
- Install DME control unit.
- Install the drive belt.
- Install cooling fan housing.
- Install catalytic converter.
> WM, 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER WITHOUT PARTICLE FILTER (R4) / WM, 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER WITH PARTICLE FILTER (R4)
- Install particle filter.
- Install cover for centre underbody.
> 519319 - REMOVE AND INSTALL COVER FOR CENTRE UNDERBODY , Refer to the appropriate service information.
- Install cover for front underbody.
> 519219 - REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY , Refer to the appropriate service information.
- Install front wheel housing liner.
> 505619 - REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER , Refer to the appropriate service information.
- Install front wheels.
- Install air cleaner housing.
- Install cross panel.
> 508119 - REMOVING AND INSTALLING CROSS PANEL (DISASSEMBLING PLENUM PANEL) , Refer to the appropriate service information.
- Install filler neck on windscreen-washer reservoir.
> 926019 - REMOVING AND INSTALLING WINDSCREEN-WASHER RESERVOIR
- Install cowl panel cover.
> 508719 - REMOVING AND INSTALLING COWL PANEL COVER , Refer to the appropriate service information.
- Install front strut.
- Install engine cover (design cover).
> 108319 - REMOVE AND INSTALL ENGINE COVER (DESIGN COVER) (R4)
- Move front lid out of service position and install standard pneumatic springs.
> 552213 - SECURING FRONT LID (SERVICE POSITION) , Refer to the appropriate service information.
- Connect ground terminal of vehicle electrical system battery.
> 270619 - REMOVING AND INSTALLING VEHICLE ELECTRICAL SYSTEM BATTERY
> 2X00IN - WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- Fill up coolant.
- Fill in ATF.
- Fill in refrigerant.