Test Values And Wear Limits For Macan Brake System - Pscb
WARNING: This page is about a different variant/trim than selected.
Front and rear brake disc wear limit:
- Read off values on the brake disc hub.
Use > VAS 6272 - paint thickness tester → Observe measuring prerequisites.
- 1.1 Wear values are lasered on the brake disc hub.
- 1.2 If the wear value is reached: Replace PSCB brake discs on each axle.
Pad thickness, front - > Control value 9.68 mm - 2 mm
Pad thickness, rear - > Control value 11.3 mm - 2 mm
Maximum lateral runout of brake disc - > Control value 0.03 mm
Maximum lateral runout of brake disc - > Control value 0.06 mm
Maximum lateral runout of wheel hub - > Control value 0.03 mm