Installing ATF Pan

WARNING: This page is about a different variant/trim than selected.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

Information

Fit new seal -1-

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF-pan seal
1. 1.1 Clean sealing face on the ATF pan -2- .
2. 1.2 Insert nubs of the new seal into the ATF pan -2- .
Clean the magnetic strips -1- and check that they are fitted over the entire surface in the ATF pan.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Magnetic strips in ATF pan
Install ATF pan -1- .

Fig 1: ATF Pan Screws Loosening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

ATF pan
1. 3.1 Clean the sealing surface on the transmission.
2. 3.2 Fit the ATF pan -1- . fit screws -2 to 16- and tighten crosswise.
  > Tightening - torque 10 Nm (7.5 ftlb.)