LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (37 Automatic Transmission - Actuator, Housing 2.9L -- 95B - MACAN (95B)) >> WM, 371319 Removing And Installing Locking Cable >> Installing Locking Cable

Installing Locking Cable

WARNING: This page is about a different variant/trim than selected.

Information 

Information 

Do not apply lateral forces to the selector knob pull rod as it can break off.

  1. Install locking cable -1-  .
    G15153187Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Locking cable

    1. 1.1  Position locking cable together with holder.
    2. 1.2  Fit and tighten screws on locking cable holder -3-  .

      > Tightening - torque 8 Nm (6 ftlb.) 

    3. 1.3  Secure ball socket -2-  .
  2. Secure locking cable to selector support
    G15153188Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Safety clip for locking cable

    1. 2.1  Guide locking cable -1-  into selector support -2-  and engage safety clip -2-  .
  3. Install heat shield -1-  .
    G15153189Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield

    1. 3.1  Position heat shield -1-  .
    2. 3.2  Tighten clamping washers -2- 
  4. Secure transmission support .
    G15153190Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Transmission support

    1. 4.1  Lift transmission and transmission support using > VAS 6931 - engine and gearbox jack  .
    2. 4.2  Fit and tighten screws -1 - and 3-  .

      > Tightening - torque 70 Nm (52 ftlb.) 

    3. 4.3  > VAS 6931 - Engine and gearbox jack  must now be removed
  5. Tighten clamping screw for locking cable using > T40031 - socket insert a/f 5-2-  .

    > Tightening - torque 13 Nm (9.5 ftlb.) 

    G15153191Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Clamping screw for locking cable

  6. Install insulating mat -1-  .
    G15153192Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Insulating mat

    1. 6.1  Position insulating mat -1-  .
    2. 6.2  Connect and lock cable plug -2- 
  7. Install switch console holder .
    G15153193Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Switch console holder

    1. 7.1  Position switch console holder and lock it in -direction of arrow-  .