Exhaust System - V6 Biturbo

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exhaust System Component Location With Torque Specification - V6 Biturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Overview of exhaust system

1	Exhaust system
2	Exhaust system holder
3	> Tightening - torque 20 Nm (15 ftlb.)
4	Studs on exhaust system holder
5	Clamps/Always replace
6	Screws on clamps
7	Nuts on clamps > Tightening - torque 30 Nm (22 ftlb.)
8	Nut securing catalytic converter/petrol particulate filter to exhaust pipe (see Petrol particulate filter (OPF))
9	Exhaust flap actuator
10	> Tightening - torque 5 Nm (3.5 ftlb.)
11	Tailpipe covers
12	> Tightening - torque 8 Nm (6 ftlb.)
13	> Tightening - torque 20 Nm (15 ftlb.)