Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Install air-conditioning compressor.
- WM, 873419 REMOVING AND INSTALLING AIR CONDITIONING COMPRESSOR
Install generator.
- WM, 272219 - REMOVING AND INSTALLING GENERATOR (V6 TURBO)
Install drive belt.
- WM, 137819 REMOVING AND INSTALLING DRIVE BELT (V6 TURBO)
Install particle filter.
- WM, 267419 REMOVING AND INSTALLING PARTICLE FILTER (V6 BITURBO)
Mount engine.
- 100127 Removing and mounting engine
Install engine.
- WM, 100119 REMOVING AND INSTALLING ENGINE (V6 TURBO)
Carry out the following Tester tasks when you start the engine for the first time:
1. 7.1 DME control unit: Automatic programming menu item.
2. 7.2 Only for Hybrid: Additional menu Decoupler commissioning.
3. 7.3 Perform adaptations and short tests and set the Ready status.
4. 7.4 Check the fault memory for relevant entries and correct them.