Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- Only if removed in order to remove the double clutch transmission:
Install power-steering gear.
- Secure the locking cable.
- Connect ATF cooling line.
- Install air-conditioning compressor.
- Secure pressure hose to charge-air cooler.
- Install front underbody cover.
- Install rear cardan shaft.
- Only for vehicles with PCCB brakes:
Install front PCCB brake discs.
- Secure front brake callipers.
- Install front wheel housing liners.
- Install front wheels.
- Install filler neck for washer-fluid reservoir.
- Fill in coolant.
- Install cowl panel cover.
- Install front strut.
- Install DME control unit.
- Secure pressure hose to throttle housing.
- Install torque support.
- Install air cleaner housing.
- Install engine cover [design cover).
- Move bonnet to its normal position.
- Connect the battery.
- Perform suspension alignment.