Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Cylinder head screw | 12.9 | Initial tightening | 50 Nm (37 ftlb.) | ||
| Cylinder head screw | 1st turn | Final tightening | + 90° | ||
| Cylinder head screw | 2nd turn | Final tightening | + 90° | ||
| Cylinder head screw (arrows) | Initial tightening | 4 Nm (3 ftlb.) | |||
| Cylinder head screw (arrows) | Final tightening | +90° | |||
| Screw-type clamp securing moulded hose to intake-air distributor | Tightening torque | 5.5 Nm (4 ftlb.) | |||
| Fastening screw securing intake manifold support | Tightening torque | 20 Nm (15 ftlb.) | |||
| Fastening nut for intake manifold support | Tightening torque | 10 Nm (7.5 ftlb.) | |||
| Fastening screw securing coolant pipe to intake manifold | Tightening torque | 6 Nm (4.5 ftlb.) |