Ignition System
WARNING: This page is about a different variant/trim than selected.
Ignition system
| 1 | Screw > Tightening - torque 10 Nm (7.5 ftlb.) |
| 2 | Ignition coil |
| 3 | Spark plug > Tightening - torque 25 Nm (19 ftlb.)
> Tightening - torque 30 Nm (22 ftlb.) Electrode gap of spark plug > Control value 0.3 mm - 0.1 mm |
| 4 | Screw/replace > Tightening - torque 20 Nm (15 ftlb.) |
| 5 | Knock sensor |
| 6 | Pulse sender/check O-fing for damage |
| 7 | Screw > Tightening - torque 10 Nm (7.5 ftlb.) |
| 8 | Screw > Tightening - torque 9 Nm (6.5 ftlb.) |
| 9 | Hall sender/replace O-fing not shown Nut securing ground line to ignition coil > Tightening - torque 10 Nm (7.5 ftlb.) |