Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screw for chain housing cover, lower | Initial tightening | 8 Nm (6 ftlb.) | |||
| Fastening screw for chain housing cover, lower | Final tightening | + 45° | |||
| Fastening screw for control unit | Tightening torque | 2.5 Nm (1.75 ftlb.) | |||
| Fastening screw for pulley | Screw 8.8/replace | Initial tightening | 150 Nm (111 ftlb.) | ||
| Fastening screw for pulley | Screw 8.8 | Final tightening | + 90 (67 ftlb.) ° | ||
| Fastening screw for pulley | Screw 10.9 replace | Initial tightening | 100 Nm (74 ftlb.) | ||
| Fastening screw for pulley | Screw 10.9 | Final tightening | + 180 (133 ftlb.) ° |