| Steering gear to front-axle carrier |
M12 x 1.5 x 153 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
80 Nm (59 ftlb.) |
|
|
| Steering gear to front-axle carrier |
M12 x 1.5 x 153 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+ 180° |
|
|
| Tie-rod ball to wheel carrier cone |
M12 x 1.5 thread/always use new nuts following removal |
Tightening torque |
100 Nm (74 ftlb.) |
|
|
| Intermediate steering shaft to steering gear (universal joint) |
M8 x 30 thread/always use new screws or bolts following removal |
Initial tightening |
20 Nm (15 ftlb.) |
|
|
| Intermediate steering shaft to steering gear (universal joint) |
M8 x 30 thread/always use new screws or bolts following removal |
Final tightening |
+ 90° |
|
|
| Bearing clamp securing stabiliser to front axle carrier |
Item 28: Collar nut M8/replace |
Tightening torque |
30 Nm (22.1 ftlb.) |
|
|