Disassembling Double Clutch Transmission

WARNING: This page is about a different variant/trim than selected.

Remove halfshaft flange.
- WM, 392519 REMOVING AND INSTALLING HALFSHAFT FLANGE
Remove drive plate.
- WM, 136319 - REMOVING AND INSTALLING DRIVE PLATE (R4)
Remove the double clutch.
- WM, 304919 REMOVING AND INSTALLING DOUBLE CLUTCH
Remove sealing ring for double clutch.
- WM, 386955 - REMOVING AND INSTALLING SEALING RING FOR DOUBLE CLUTCH
Remove drive shaft bearing.
- WM, 380919 - REMOVING AND INSTALLING DRIVE SHAFT BEARING
Remove ATF pan.
- WM, 375519 - REMOVING AND INSTALLING ATF PAN
Remove transmission control mechanism.
- WM, 387719 - REMOVING AND INSTALLING CONTROL MECHANISM FOR TRANSMISSION
Remove ATF pump.
- WM, 385619 - REMOVING AND INSTALLING ATF PUMP
Remove sealing ring for from output shaft.
- WM, 387055 - REPLACING SEALING RING FOR REAR OUTPUT SHAFT
Remove wire harness.
- WM, 381819 - REMOVING AND INSTALLING WIRE HARNESS
Remove sensor module.
- WM, 381919 - REMOVING AND INSTALLING SENSOR MODULE