Checking Thickness Tolerance
WARNING: This page is about a different variant/trim than selected.
Information
- The required technical values must be taken from the
> 4600TW - PSCB TECHNICAL VALUES AND WEAR LIMITS
document.
- Remove wheel.
> 440519 - REMOVING AND INSTALLING WHEEL - SECTION ON "REMOVING"
- Use a suitable micrometer screw to measure the thickness tolerance at 8 points within the braking surface.
- 2.1 Compare measured values with the specifications and continue according to the results.
- Fit wheel.
> 440519 - REMOVING AND INSTALLING WHEEL - SECTION ON "INSTALLING"