Removing Brake Pedal
WARNING: This page is about a different variant/trim than selected.
- Disconnect brake pedal -1-
from brake booster push rod -2-
.
Brake booster push rod on brake pedal
- 1.1 Press the brake pedal -1- towards the brake booster by hand -arrow A- .
- 1.2 > T40136 - Release tool must be positioned at the retaining lugs -3- of the ball joint mounting.
- 1.3 Release retaining lugs of the ball joint mounting -3- by moving them towards the driver seat using > T40136 - release tool and counter at the brake pedal -1- at the same time (the brake pedal must not move towards the driver seat).
- 1.4 Separate the brake pedal -1- from the push rod using > T40136 - release tool by moving it towards the driver seat -arrow B- .
- Remove brake pedal -1-
.
Brake pedal
- 2.1 Remove safety clip -2- .
- 2.2 Remove pedal bearing shaft -3- .
- 2.3 Remove brake pedal -1- from the footwell.