Installing The Moulded Hose (Pressure Pipe - Throttle Body)
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Align markings on the moulded hose at 12 o'clock position.
- 1.2
Tighten the screw clamp of the moulded hose on the pressure pipe on top
- Tightening torque 5.5 Nm (4 ftlb.)
- 1.3
Tighten the screw clamp of the pressure hose on the throttle body.
- Tightening torque 5.5 Nm (4 ftlb.)