| Screws on protective plate for supply line section on underbody |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw on line bracket for supply line section on underbody |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw on line bracket for supply line section in engine compartment |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screw on line bracket for supply line section at high-pressure pump |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Nuts securing line bracket for supply line section at high-pressure pump |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Union nut for fuel line |
Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. |
tightening torque of |
10 Nm (7.4 ftlb.) |
|
|