| Screw securing oil windage tray to crankcase |
M6 x 18 (3 ea.)/replace, tighten in diagonally opposite sequence |
Initial tightening |
3 Nm (2 ftlb.) |
|
|
| Screw securing oil windage tray to crankcase |
M6 x 18 (3 ea.)/replace, tighten in diagonally opposite sequence |
Final tightening |
+ 90° |
|
|
| Connecting rod bolts |
Oil thread and contact surfaces/replace |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting rod bolts |
Oil thread and contact surfaces/replace |
Final tightening |
+ 90° |
|
|
| Banjo bolt for oil spray jet |
|
Initial tightening |
10 Nm (7.5 ftlb.) |
|
|
| Banjo bolt for oil spray jet |
|
Final tightening |
+ 45° |
|
|