Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link to anti-roll bar | M10 x 65 thread/always use new screws and nuts following removal | Initial tightening | 50 Nm (37 ftlb.) | ||
| Connecting link to anti-roll bar | M10 x 65 thread/always use new screws and nuts following removal | Final tightening | + 90° | ||
| Connecting link to lower trailing arm | M10 x 65 thread/always use new screws or bolts following removal | Initial tightening | 50 Nm (37 ftlb.) | ||
| Connecting link to lower trailing arm | M10 x 65 thread/always use new screws or bolts following removal | Final tightening | + 90° |