Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Wheel bearing to wheel bearing housing | M12 x 1.5 x 45 thread/observe installation sequence!/always use new screws or bolts following removal | Initial tightening | 80 Nm (59 ftlb.) | ||
| Wheel bearing to wheel bearing housing | M12 x 1.5 x 45 thread/observe installation sequence!/always use new screws or bolts following removal | Final tightening | + 90° |