Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Upper control arm to rear axle housing | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 70 Nm | ||
| Upper control arm to rear axle housing | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 180° | ||
| Upper control arm to wheel bearing housing | M12 thread | Tightening torque | 95 Nm |