Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Tie rod to rear axle housing | M12 thread/always use new screws or bolts and nuts following removal | Tightening torque | 95 Nm | ||
| Tie rod to wheel bearing housing | M12 x 1.5 x 80.8 thread/always use new screws or bolts following removal | Initial tightening | 90 Nm | ||
| Tie rod to wheel bearing housing | M12 x 1.5 x 80.8 thread/always use new screws or bolts following removal | Final tightening | + 90° |