Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Connecting link to anti-roll bar | Item 3: AM10 thread/Always replace screws and nuts following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Connecting link to anti-roll bar | Item 3: AM10 thread/Always replace screws and nuts following removal | Final tightening | + 90° | ||
| Roll bar clamp to front-axle carrier | Item 4: M8 thread/always replace nut following removal | Tightening torque | 30 Nm (22 ftlb.) |