Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Lower control arm to frontaxle carrier | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 70 Nm | ||
| Lower control arm to frontaxle carrier | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 180° | ||
| Lower control arm to wheel bearing housing | M14 thread/always use new nuts following removal | Tightening torque | 140 Nm |