LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 Exhaust Gas Turbocharging 2.0L -- 95B - MACAN (95B) >> WM, 213919 Removing And Installing Moulded Hose (R4) >> Installing Moulded Hose >> Installing The Moulded Hose (Pressure Pipe - Throttle Body)

Installing The Moulded Hose (Pressure Pipe - Throttle Body)

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Align markings on the moulded hose at 12 o'clock position.
    2. 1.2  Tighten the screw clamp of the moulded hose on the pressure pipe on top
      • Tightening torque 5.5 Nm (4 ftlb.) 
    3. 1.3  Tighten the screw clamp of the pressure hose on the throttle body.
      • Tightening torque 5.5 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals