Technical Values
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Shock absorber to wheel bearing housing | M14 x 1.5 x 90 thread/always use new screw or bolt following removal | Initial tightening | 150 Nm | ||
| Shock absorber to wheel bearing housing | M14 x 1.5 x 90 thread/always use new screw or bolt following removal | Final tightening | + 180° | ||
| Shock absorber to body | AM10 x 35 thread/always use new screws or bolts following removal | Initial tightening | 50 Nm | ||
| Shock absorber to body | AM10 x 35 thread/always use new screws or bolts following removal | Final tightening | + 90° |