| Connecting link to anti-roll bar |
M10 x 65 thread/always use new screws and nuts following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link to anti-roll bar |
M10 x 65 thread/always use new screws and nuts following removal |
Final tightening |
+ 90° |
|
|
| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Final tightening |
+ 90° |
|
|