Technical Values

Location	Description	Type	Basic value
Connecting link to anti-roll bar	M10 x 65 thread/always use new screws and nuts following removal	Initial tightening	50 Nm (37 ftlb.)
Connecting link to anti-roll bar	M10 x 65 thread/always use new screws and nuts following removal	Final tightening	+ 90°
Connecting link to lower trailing arm	M10 x 65 thread/always use new screws or bolts following removal	Initial tightening	50 Nm (37 ftlb.)
Connecting link to lower trailing arm	M10 x 65 thread/always use new screws or bolts following removal	Final tightening	+ 90°
Anti-roll bar clamp to rear axle carrier	M8 x 65 thread/always use new screws following removal	Initial tightening	20 Nm (15 ftlb.)
Anti-roll bar clamp to rear axle carrier	M8 x 65 thread/always use new screws following removal	Final tightening	+ 180°
Level sensor to lower trailing arm	M6 x 16 thread	Tightening torque	9 Nm