| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Initial tightening |
50 Nm (37 ftlb.) |
|
|
| Connecting link to lower trailing arm |
M10 x 65 thread/always use new screws or bolts following removal |
Final tightening |
+ 90° |
|
|
| Lower trailing arm to rear axle housing |
M12 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
70 Nm |
|
|
| Lower trailing arm to rear axle housing |
M12 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+ 180° |
|
|
| Lower trailing arm to wheel bearing housing |
M14 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
120 Nm |
|
|
| Lower trailing arm to wheel bearing housing |
M14 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+ 360° |
|
|
| Level sensor to lower trailing arm |
M6 x 16 thread |
Tightening torque |
9 Nm |
|
|