Technical Values

Location	Description	Type	Basic value
Tie-rod ball to wheel carrier cone	M12 x 1.5 thread/always use new nuts following removal	Tightening torque	100 Nm (74 ftlb.)
Lower trailing arm to wheel bearing housing	M14 thread/always replace nuts following removal	Tightening torque	140 Nm (104 ftlb.)
Lower trailing arm to front axle carrier	M12 thread/always use new screws or bolts and nuts following removal	Initial tightening	70 Nm
Lower trailing arm to front axle carrier	M12 thread/always use new screws or bolts and nuts following removal	Final tightening	+ 180°
Level sensor to lower trailing arm	M6 thread	Tightening torque	9 Nm
Spring strut to lower trailing arm	M12 thread/always use new screws or bolts and nuts following removal	Initial tightening	90 Nm (67 ftlb.)
Spring strut to lower trailing arm	M12 thread/always use new screws or bolts and nuts following removal	Final tightening	+ 90°