Installing Cover For Centre Underbody
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws on cover for centre underbody at the left to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten nuts on left heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten nuts on holder to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten screws on rear side cover to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten screws on cover for centre underbody at the right to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten nuts on cover for centre underbody at the right to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten screws on right heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten nuts on right heat shield to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten screws on central cover for centre underbody to > Tightening torque 2.5 (1.75 ftlb.) Nm .
Tighten screws on central cover for centre underbody to > Tightening torque 3.5 (2.5 ftlb.) Nm .