Checking Thickness Tolerance

Information 

• The required technical values must be taken from the 

  > 4600TW - PSCB TECHNICAL VALUES AND WEAR LIMITS 

  document. 

1. Remove wheel.

   > 440519 - REMOVING AND INSTALLING WHEEL - SECTION ON "REMOVING"

2. Use a suitable micrometer screw to measure the thickness tolerance at 8 points within the braking surface.
   1. 2.1 Compare measured values with the specifications and continue according to the results.
3. Fit wheel.

   > 440519 - REMOVING AND INSTALLING WHEEL - SECTION ON "INSTALLING"