Fitting Rear Logo

Information 

• Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol. 
• Always use a clean cloth. 
• The room and object temperature must be at least  > Nominal value + 15°C  .
• Air humidity must be  > Nominal value 50 % +/-10 %  .
• Do not touch the bonding surface again after removing the protective paper. 
• Wear clean gloves during the bonding process in order to guarantee adequate adhesion. 
• The parts must have been bonded for at least  > Nominal value 72 h before - washing the vehicle in a car wash. 

Information 

To ensure that the logo template does not lose its shape, always store the logo template on the relevant support (packaging) after using it.

Logo template - Macan  > 9957 - Logo template - "Macan" 

Logo template - Macan S  > 9957/1 - Logo template - "Macan S" 

Logo template - Macan turbo  > 9957/2 - Logo template - "Macan turbo" 

Logo template, Macan GTS  > 9957/3 - Logo template "Macan GTS" 

1. Position logo template on the vehicle.
2. Remove protective paper from the rear logo.
3. Align rear logo using the logo template and press it on firmly.
4. Remove logo template from the vehicle.