Installing Switch Console
Information
CAUTION:
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work.
- Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation.
- Do not touch electric pins and plug contacts.
Information
CAUTION:
The switch console must be disengaged and engaged carefully.
Because of its design, pressure must not be exerted on just one side of the switch console during removal and installation.
The switch console must be unclipped and clipped in on the left and right side at the same time.
Because of its design, pressure must not be exerted on just one side of the switch console during removal and installation.
The switch console must be unclipped and clipped in on the left and right side at the same time.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening screws securing switch console to centre console to > Tightening - torque 4 Nm (3 ftlb.) .