Activating PCC/PVTS

NOTIFICATION 

Voltage drop 

• Irreparable damage to control unit 
• Damage to control unit 
• Fault entries in the control unit 
• Control unit programming/coding is aborted 
• Malfunctions in the control unit, even during programming 
  1. → Switch off ignition before disconnecting the control unit.
  2. → Make sure that the power supply is not interrupted during programming/coding.
  3. → Connect the battery charger with at least > current 90 A  to the vehicle battery.

Information 

Make sure that you have sufficient mobile phone and satellite reception.

Information 

The > 9900 - PIWIS Tester 3  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms; different text or additions may appear in > 9900 - PIWIS Tester 3  .

Information 

PCC/PVTS should be activated just before vehicle handover as the customer has access to the vehicle and the term of the PCC/PVTS contract begins following activation.

1. Get installation code from the customer.

   Information 

   If the installation code is not available, PCC/PV TS activation must be carried out during vehicle handover.

2. Connect the Tester to the vehicle and start it. Switch on ignition.
3. Select the vehicle type if required.
4. In the overview,  press F7 to switch to the Additional menu. 
5. PCC/PVTS commissioning  must now be selected. Press F12 to continue.
6. Read and follow the instructions and information on the Tester.

   Perform activation according to menu guidance.

7. Log PCC/PVTS activation.
8. Switch off ignition and then switch it on again.
9. Read out the fault memory, correct faults that are stored if necessary and clear the fault memory.
10. Exit the diagnostic application. Switch off ignition. Disconnect the Tester from the vehicle.