Installing Vehicle Electrical System Battery
WARNING:
Static battery charge
- Battery can explode
- Electrical discharges
- → Do not rub the battery with a dry cloth.
Information
Switch off all loads and remove the ignition key.
- Do not disconnect the battery while the engine is running.
- Disconnect and re-connect battery with extreme caution.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening screw on clamp support for battery to > Tightening - torque 23 Nm (17 ftlb.) .
Tighten fastening nuts on terminal clamps to > Tightening - torque 6 Nm (4.5 ftlb.) .