| Screws securing cardan shaft bearing to body |
M8 x 25 |
Tightening torque |
20 Nm (15 ftlb.) |
|
|
| Screws securing cardan shaft to rear axle differential/M10 |
Step 1 |
Initial tightening |
18 Nm |
|
|
| Screw securing cardan shaft to rear axle differential/M10 |
Step 2 |
Initial tightening |
50 Nm |
|
|
| Screws securing cardan shaft to rear axle differential/M10 |
Final tightening |
Final tightening |
+ 120° |
|
|
| Screws on front tunnel support |
M10 x 25 |
Initial tightening |
60 Nm (44 ftlb.) |
|
|
| Screws on front tunnel support |
M10 x 25 |
Final tightening |
+ 45° |
|
|
| Screws on rear tunnel cross member |
M10 x 30 |
Tightening torque |
55 Nm (41 ftlb.) |
|
|
| Screws securing heat shield to tank holder |
|
Tightening torque |
15 Nm (11 ftlb.) |
|
|
| Nut securing heat shield to body |
|
Tightening torque |
2 Nm (1.5 ftlb.) |
|
|