Pulling Punch Rivets

Information 

The following description is intended only as a guide. A desciption of the steps involved and the various areas of application can be found in the operating instructions provided with the respective device.

1. Set up stud welder and prepare components for welding.

   > 5X00IN11 STUD WELDING 

   WELDING PARAMETERS FOR PULLING PUNCH RIVETS
   
   

   Bolt	Welding time [ms]	Amperage rating [A]	Lift [mm]	Gas pre-flow time [ms]	Gas parameters [l/min]	Power terminal	Ground terminal	Polarity
   Stainless-steel bolt, M6	32	650	1.0	1, 000	10	Component	Gun	Polarity reversed
   Stainless-steel bolt, M5	30	600	1.0	1, 000		Component	Gun	Polarity reversed

2. Weld the weld stud onto the rivet head of the punch rivet.

   > 5X00IN11 STUD WELDING 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Welding on weld stud

3. Pull out punch rivet at the welded-on weld stud using a hydraulic riveting tool > VAS 6790 - Compact booster  with tool attachment > VAS 6792/2 - Extension  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Pulling punch rivets