Removing (Outer) Rear Wheel Housing

Information 

Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

Information 

Loosen connection points on one side only. Do not damage the sheet-metal panel underneath.

Information 

Make sure to leave an overlap of approx 20 mm on the wheel housing.

1. Mark and make cut. > Distance 20 mm 
2. Remove (outer) rear wheel housing.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Rear wheel housing (outer)

3. Remove remaining pieces of (outer) rear wheel housing.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Remaining pieces

   1. 3.1  Drill out spotwelds using > VAS 882 001 - spot-weld remover  .