LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan Base >> Repair and Diagnosis (Single Page) >> Collision >> Body Panels >> 51 - Body Center, Roof, Frame >> WM, 510955 Replacing Rear Cross Member >> Subsequent Work >> Subsequent work for body repairs (without straightening system)

Subsequent work for body repairs (without straightening system)

  1. Clean joint areas and sheetmetal flanges with a wire brush.
  2. Prime joint areas and sheetmetal flanges with 2-component primer.
  3. Restore standard seal with body sealant

    > *** 5X00IN42 Seam sealing

    Also seal the repair area carefully.

  4. Paint repair area and adjacent surfaces, if necessary.
  5. Restore standard underbody protection with underbody sealant

    > 5X00IN43 UNDERBODY PROTECTION

  6. Apply standard cavity preservation

    > 5X00IN44 CAVITY PRESERVATION

    Also apply cavity preservation to the repair area.

  7. Install removed add-on parts in the repair area.
scientia non olet · About LEMON Manuals