LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan Base >> Repair and Diagnosis (Single Page) >> Collision >> Body Panels >> 51 - Body Center, Roof, Frame >> WM, 510555 Replacing Roof Pillar (Outer Panel) >> Preparing Roof Pillar (Outer Panel) For Installation

Preparing Roof Pillar (Outer Panel) For Installation

  1. Fit rear side section.
    1. 1.1  Cut rear side section at the transitions to the body leaving an overlap of 30 mm.
      G14361208Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Roof pillar (outer panel)

  2. Fit in roof pillar (outer panel) again.
    1. 2.1  Make cuts through the roof pillar (outer panel) and body in the overlap areas.
  3. Prepare connection areas for bonding and welding.

    > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

    G14361209Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Roof pillar (outer panel)

    Red Plug-welding/apply a full weld using inert gas without bonding
    Green Resistance spot-welding
    Yellow Bonding + resistance spot-welding
scientia non olet · About LEMON Manuals