Installing Roof Trim Panel

Information 

Make sure that the roof cover does not buckle.

Information 

Check that the fixing clips are not bent or broken.

Replace missing or damaged fixing clips with new ones.

Make sure that all guide tabs and locking lugs are positioned correctly.

Check that they are fitted correctly.

1. Installation is performed in reverse order. Pay particular attention to the following:

Tighten screw under the roof console to > Tightening - torque 5 Nm (3.7 ftlb.)  .

Tighten screw on net cover holder to > Tightening - torque 9 Nm (6.5 ftlb.)  .