Installing Rear Apron

1. Installation is performed in reverse order. Pay particular attention to the following:
   1. 1.1  To prevent damage, stick an adhesive strip at the points where the tail lights join the rear apron.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Adhesive strip

   2. 1.2  Tighten screws on the retaining strip to > Tightening torque 2 (1.5 ftlb.) Nm  .
   3. 1.3  Tighten screws on the underbody to > Tightening torque 2 (1.5 ftlb.) Nm  .
   4. 1.4  Tighten screws on the wing to > Tightening torque 2 (1.5 ftlb.) Nm  .
   5. 1.5  Tighten screws for the wheel housing liners to > Tightening torque 2 (1.5 ftlb.) Nm  .
   6. 1.6  Tighten screws on the guide pins for the tailgate to > Tightening torque 10 (7.5 ftlb.) Nm  .
   7. 1.7  Remove strip of adhesive tape.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adhesive strip