LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Macan Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> 5X - Body General >> WM, 5X00IN22 Working With Body Foam Filler >> Working With Body Foam Filler >> Processing Conditions

Processing Conditions

During processing, the ambient and material temperature must be at least > Minimum temperature 15 °C  and must not exceed a maximum temperature of > Maximum temperature 28 °C  .

Higher processing temperatures reduce processing time. Processing can be interrupted briefly for up to 5 minutes.

> Processing time at 15 °C 20 min 

> Processing time at 28 °C 15 min 

The chemical reaction is essentially complete after approx. 30 minutes. The hardened foam does not swell or shrink.

scientia non olet · About LEMON Manuals