Preparing Connection Areas Of The Body For Installing Rear Side Member (Section)

Information 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Align contact surface and connections of the body.
2. De-burr connection points.
3. Prepare marked areas for installation.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection areas

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Connection areas