Removing front longitudinal member (front section)

Information 

• The final dimension is measured from the new front side member (front section). 
• The cut is only permitted at this point in front of the internal reinforcement. 
• Ensure to make a straight cut. 

1. Cut side member in accordance with the new part.
   Fig 1: Checking Front Longitudinal Member (Front Section) Cutting Dimension

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Front longitudinal member (front section)

   1. 1.1  Mark and make cuts all around. > Distance 158 mm 
2. Fit sub-part using the straightening set. Cut side member to length as required.